Making Vinyl Stripes On A Boat Look Wet

Work the stripe along its entire length.

Making vinyl stripes on a boat look wet.

Squeegee the stripe from its lateral center outward to squeeze out as many air pockets as possible. They are available in a variety of widths and colors metallic and reflective colors cost more. The mold is first sprayed with gelcoat then fiberglass cloth is applied and then resin is used to saturate or wet out the fiberglass. Stripes should be installed without water except for larger stripes 3 or wider.

With fiberglass boat building however the major components of the boat the hull deck liner and large parts like consoles are molded from fiberglass. Due to copyright laws we are unable to reproduce manufacturer striping packages. Use personal discretion with 3 or wider stripes if a wet installation is desired follow instructions for wet graphic installation but do not hinge stripes. Usually this means starting with a female mold.

Use a flexible plastic squeegee to press down on the stripe and ensure that the vinyl adheres well to the hull. Dip your boat with plastidip world 1st. Step 1 clean off any superficial dirt from the vinyl decals with a soft cloth and a solution of detergent and water. Vinyl wrap a boat in gloss black and diamond blue.

Once you re done there will still be a few air blisters you can t squeegee away. How to spray racing stripes with plasti dip duration.